News:

Due to SPAM attacks, new members must be approved before posting.  Please email jclough@warrenpinnacle.com when registering and your account will be approved.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - JulianO

#1
Using SLAMM / Re: DEM/3d tool issue
September 22, 2011, 11:41:56 PM
Hi Amy,

Thanks for the feedback. It turned out to be an issue with the DEM.
I have found a DEM with higher resolution and this has proved to be the best solution.

Thanks,

Julian.
#2
Using SLAMM / DEM/3d tool issue
September 20, 2011, 12:33:03 AM
Hi,

Just after a bit of guidance.
It appeared as though everything was running smoothly with my model, until I used the 3D graph tool. Upon doing so the sea level toggle tool showed that MSL didn't align with the water coverage in my NWI input.

Could this be an issue with my DEM, perhaps it is not accurate enough?

Any advice would be great.

Thanks,

Julian