Due to SPAM attacks, new members must be approved before posting.  Please email when registering and your account will be approved.

Main Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - kij4

Using SLAMM / Re: NWI
February 22, 2017, 06:23:33 AM
Thank you!

I got it working in the end, I followed the steps on the other thread but wasn't working. My friend got it working after noticing the file wasn't exporting properly!

Thank you for your assistance though.
February 12, 2017, 10:43:44 AM

I was just wondering how you incorporate NWI codes into SLAMM, I am a beginner with SLAMM and computer codes in general, I am struggling with the incorporating of the NWI codes. I have got a friend who has helped with the conversion of slope and DEM data but we are both stuck on the NWI codes!

I got the main bulk of my dem and aerial imagery from earth explorer and has been manipulated in arcmap, and exported! I am just struggling with the NWI, any advice or help will do!

Many thanks,
Using SLAMM / Using SLAMM wih Arcmap
January 07, 2017, 07:04:27 AM

I am hoping to use SLAMM 6 for my undergraduate dissertation. However I am struggling, I have my data in arc map, I have exported the slope & Dem as .tiff files, I assumed the NWI was the area of salt marshes I was using however this does not seem to be the case when I try and execute with the data I have the following message comes up:

Data file "" Does Not Include" "no data_value" identifier

The salt marshes I am using have an accumulation rate of 10 mm/yr. and I am not sure what I am doing with the progamme I have tried to figure it out myself but I can't seem to get it right.

Can anyone help me with regards to exporting the data I have in Arcmap into SLAMM 6, and any tips on how to get it to all work.

I will be eternally grateful for anything that would help, as my department isn't willing to help at this point.