News:

Due to SPAM attacks, new members must be approved before posting.  Please email jclough@warrenpinnacle.com when registering and your account will be approved.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Ed_TBEP

#1
Using SLAMM / Re: Range Check Errors in 6.0.1
August 24, 2010, 01:23:26 PM
Well, I decided to start over from scratch instead of loading my canned simulation file. I re-entered all my site parameter characteristics and for two accretion rates I chose to use only values rounded to the tenth decimal. I also chose fewer scenarios to run, and voila...SLAMM is currently executing...

Not sure what I might have changed to prevent the range check error from occurring, but it is at least running through the A1B Max scenario right now!!!
#2
Using SLAMM / Re: Range Check Errors in 6.0.1
August 24, 2010, 10:56:43 AM
I just tried to execute a run on a Win 7 64-bit system (4gb ram), but I am still getting the range check error. The same deal as on a Win XP 32bit system, I can draw the map, run an elevation analysis, but when I try to execute a run, I immediately get a range check error dialog. I feel like I'm overlooking something simple, but can't figure out what will get a test run going with my input files... Any suggestions???
#3
Using SLAMM / Re: Range Check Errors in 6.0.1
August 23, 2010, 08:19:08 AM
Thanks Evan.

I will try to execute the run on a 64-bit Win 7 system and post my results this week.
#4
Using SLAMM / Re: Range Check Errors in 6.0.1
August 16, 2010, 01:27:26 PM
I've created all the rasters using the same extent and cell counts, as I first suspected this may be the problem--but I still get the errors regardless of the cell size I try to employ.

I've also used the "Count" button before running the simulation/set map attributes, but still get the errors. I haven't tried a 64-bit OS system >4gb ram yet, though.

Jonathan, I sent an email to you directly to get the FTP details. Thanks again for your help.
#5
Using SLAMM / Range Check Errors in 6.0.1
August 12, 2010, 07:19:25 AM
I have tried various scales (3m, 5m, 10m pixel) and clipped areas (entire Tampa Bay region, specific bay segments) in attempt to run SLAMM. At first I was getting out of memory errors, but as I've reduced the raster file sizes, I now get range check errors. I get past the point of "Set Attributes" and the maps drawing, but as soon as I try to execute the model I receive the "Range check error." I'm stumped at this point--my total memory use is <1GB with my current run and the file check doesn't seem to be showing any errors. Anybody have any suggestions of what to try to get the SLAMM model running???