SLAMM Forum

General Category => Using SLAMM => Topic started by: Madalyn Murray OHair on January 14, 2014, 01:42:47 PM

Title: Error codes
Post by: Madalyn Murray OHair on January 14, 2014, 01:42:47 PM
I'm getting-off to a bit of a rough start using SLAMM. Basing Global-only site parameters on the nearby Cedar Key (FL) model, I've loaded ascii files from DEM, slope, and NWI rasters that I created in ArcMap.

When executing the model, I get an error message of -.9999; and when trying to re-open the File Setup tab, I receive an error message of 2392.

Does SLAMM publish error codes?

Madelyn
Title: Re: Error codes
Post by: Jonathan S. Clough on January 14, 2014, 01:59:19 PM
Strangely I've never heard of those codes nor seen them, I don't think.  Do you think you can send to us the files so that we can try to figure out what is going on?  SLAMM is not perfect about error messages (obviously!) but usually tries to provide english-language messages. 

If you can't send us the files, maybe a screen capture showing the error message codes?

Good luck -- Jonathan
Title: Re: Error codes
Post by: Hayley Bahr on January 27, 2014, 12:55:40 PM
I am new to SLAMM and I have been running some test simulations and sometimes I get an error message saying "Cannot make a visible window modal," the error comes up just before the final step when executing the simulation. I am just asking for someone with more experience with this to tell me what it means or ideas as to what I am doing wrong, because I don't always get the error message.

Thanks in advance!
Title: Re: Error codes
Post by: Jonathan S. Clough on January 27, 2014, 01:13:24 PM
It sounds to me like a bug somewhere but I haven't seen that bug.  I am emailing my team and also sending you a link to the latest version of the code.   For general information, we recently got permission from USFWS to release SLAMM 6.2 (64-bit) publicly as soon as we get around to posting it!