SLAMM Forum

General Category => Using SLAMM => Topic started by: kevros on November 25, 2013, 11:52:45 AM

Title: Disconnected extent
Post by: kevros on November 25, 2013, 11:52:45 AM
Does SLAMM allow disconnected extents? I am trying to run the model on 3 islands are all part of 1 park.  I would like to run the model once for the park but have 3 disconnected rectangular extents to avoid all the open water/small island in betweeen.  Is this possible?
Title: Re: Disconnected extent
Post by: Jonathan S. Clough on November 25, 2013, 11:57:23 AM
This shouldn't cause a problem, using "blank" space in the middle.  Make sure there is some water surrounding each island for context, however.  You can also draw "output sites" around each extent if you want results broken out in that manner as well.   Good luck.  -- Jonathan