July 21, 2017, 12:45:58 AM

News:

Due to SPAM attacks, new members must be approved before posting.  Please email jclough@warrenpinnacle.com when registering and your account will be approved.


Initial Condition Change in Wetland Category

Started by maryramirez, January 23, 2017, 10:53:04 AM

previous topic - next topic
Go Down

maryramirez

I am using SLAMM for the Hood Canal area in Puget Sound. I have 2 issues I'm seeking advice on:

1. Considerable areas of Undeveloped Dry Land transition to Trans. Salt Marsh category at time zero. I have adjusted the elevation range and lowered the Salt Elevation. Changing the Salt Elevation has helped this issue, though I still have Trans. Salt Marsh fringing Tidal Flats all along the shoreline where there was none in the input data. I'm somewhat okay with where this is at, but if anyone has other suggestions to try, that would be great.

2. All of the Tidal Swamp cells transition to Inland Shore at time zero. This I can't figure out. I have adjusted the elevation range and the elevation analysis (attached) doesn't seem to point to a problem (less than 5% of cells are below min elev). The model shows Tidal Swamp on the Set Map Attributes screen, but all outputs (including Initial Condition) have those cells as Inland Shore. Any advice here would be greatly appreciated.

maryramirez

Follow up to the 2nd issue I described:
The (erroneous) switch from tidal swamp to inland shore occurs when using SLAMM 6.7. I just ran all the same datasets/parameters using SLAMM 6.2, and tidal swamp remains. Is this an issue with the latest version of the software?

Jonathan S. Clough

March 02, 2017, 02:03:58 PM #2 Last Edit: March 02, 2017, 02:36:50 PM by Jonathan S. Clough
Sorry about the delay in response.  

This was an error in SLAMM 6.7 output to GIS files.  

It has been fixed in a maintenance output that I'm posting today. See http://warrenpinnacle.com/SLAMMFORUM/index.php?topic=201.0

Thanks!


Go Up